Most laboratories are designed with eyewash stations and at least one safety shower depending on the size of the department. The use of these safety showers is not common, but it does happen, and the staff needs to be prepared for such an event. That preparation not only involves testing and training on equipment use, but also in making sure the physical space is ready for a potential deluge of water that can pour down into the department for potentially up to fifteen minutes. Other flooding incidents may occur as well. A floor drain can back up, a water line connected to an analyzer might break, or water might even come through the ceiling from a pipe above the department. Being prepared and responding efficiently to these types of flooding events should be part of the overall lab safety program.
One reason safety specialists and some regulatory agencies require that items in the lab not be stored directly on the floor is so they will not be damaged in the event of a departmental flood. It is generally acceptable to store plastic items (waste bins, etc.) on the floor since they cannot be damaged by water. Cardboard, computer hard drives, and other like items should be stored on palettes or shelves. Securing electrical wires and raising multi-plug adaptors off the floor is also a best practice.
When designing or remodeling a laboratory, consider the possibility of floods when choosing the type of flooring to be installed. The best laboratory flooring is monolithic, like a sheet vinyl that has few seams. It should bend up to the walls to create a coved base that is integral with the floor. This design (recommended by the CDC and CLSI) keeps liquids from going under tiles or through walls which will create more problems (like mold) down the road.
Floor drains where safety showers exist are not required, and many labs have showers where there is no drain at all. Remember that in a typical situation where a shower would be used, hazardous chemicals are involved. Any hazardous waste that might go into the sanitary sewer should be routed through a neutralization station or into a hazardous waste collection tank. The ANSI requirements for a safety shower include the ability to deliver 20 gallons of water per minute for 15-20 minutes. That’s a total of 400 gallons. The requirements also state that the water pattern must be at least 20” in diameter and 60” above the floor. Therefore, a majority of the water will not even travel to the drain. It will go to the lowest point of the floor in the department. The bottom line is, if the safety shower must be used, a flood should be expected.
In order for the lab to be prepared for a flood emergency, materials should be on hand that will help contain large amounts of water. Those materials may include large volume spill kits with booms or dikes that are capable of holding water back. Staff should be trained how to use these materials as spill training is provided, and drills should be conducted so they can use the supplies comfortably. Make sure these spill materials are easily accessible and that signage clearly indicates where they are stored.
What does the physical anatomy of your lab look like? Is it designed for safety in the event of a hazardous material spill or exposure? Is the department set up to handle a sudden flood situation, and can staff identify the steps to take to respond efficiently and safely? Take a look around your lab today, and make any necessary corrections so that all will be ready should a laboratory flood occur for any reason.